Cover for Laminar Flow Forced Convection in Ducts

Laminar Flow Forced Convection in Ducts

A Source Book for Compact Heat Exchanger Analytical Data

Book1978

Authors:

R.K. Shah and A.L. London

Laminar Flow Forced Convection in Ducts

A Source Book for Compact Heat Exchanger Analytical Data

Book1978

 

Cover for Laminar Flow Forced Convection in Ducts

Authors:

R.K. Shah and A.L. London

About the book

Browse this book

Book description

Laminar Flow Forced Convection in Ducts is a sourcebook for compact heat exchanger analytical data. This book describes the analytical solutions for laminar fluid flow and forced c ... read full description

Browse content

Table of contents

Actions for selected chapters

Select all / Deselect all

  1. Full text access
  2. Book chapterAbstract only

    Chapter I - Introduction

    Pages 1-4

  3. Book chapterAbstract only

    Chapter II - Differential Equations and Boundary Conditions

    Pages 5-36

  4. Book chapterAbstract only

    Chapter III - Dimensionless Groups and Generalized Solutions

    Pages 37-60

  5. Book chapterAbstract only

    Chapter IV - General Methods for Solutions

    Pages 61-77

  6. Book chapterAbstract only

    Chapter V - Circular Duct

    Pages 78-152

  7. Book chapterAbstract only

    Chapter VI - Parallel Plates

    Pages 153-195

  8. Book chapterAbstract only

    Chapter VII - Rectangular Ducts

    Pages 196-222

  9. Book chapterAbstract only

    Chapter VIII - Triangular Ducts

    Pages 223-246

  10. Book chapterAbstract only

    Chapter IX - Elliptical Ducts

    Pages 247-252

  11. Book chapterAbstract only

    Chapter X - Other Singly Connected Ducts

    Pages 253-279

  12. Book chapterAbstract only

    Chapter XI - Small Aspect Ratio Ducts

    Pages 280-283

  13. Book chapterAbstract only

    Chapter XII - Concentric Annular Ducts

    Pages 284-321

  14. Book chapterAbstract only

    Chapter XIII - Eccentric Annular Ducts

    Pages 322-340

  15. Book chapterAbstract only

    Chapter XIV - Other Doubly Connected Ducts

    Pages 341-353

  16. Book chapterAbstract only

    Chapter XV - Longitudinal Flow over Circular Cylinders

    Pages 354-365

  17. Book chapterAbstract only

    Chapter XVI - Longitudinal Fins and Twisted Tapes within Ducts

    Pages 366-384

  18. Book chapterAbstract only

    Chapter XVII - Discussion—An Overview for the Designer and the Applied Mathematician

    Pages 385-420

  19. Book chapterNo access

    Nomenclature

    Pages 421-427

  20. Book chapterNo access

    Appendix

    Pages 428-430

  21. Book chapterNo access

    References

    Pages 431-455

  22. Book chapterNo access

    Author Index

    Pages 457-467

  23. Book chapterNo access

    Subject Index

    Pages 468-477

About the book

Description

Laminar Flow Forced Convection in Ducts is a sourcebook for compact heat exchanger analytical data. This book describes the analytical solutions for laminar fluid flow and forced convection heat transfer in circular and noncircular pipes, including applicable differential equations and boundary conditions involving velocity and temperature problems of fluid flow. The book also discusses fluid flow—how much power is required to pump fluids through the heat exchanger, as well as the heat transfer—the determination of q" distribution, and the temperature of fluid and walls. The text also analyzes the coolant or heat transfer fluid flows in a nuclear power reactor composed of a bundle of circular section fuel rods located inside a round tube. R.A. Axford addresses fluid flow and heat transfers results for the rod bundle geometry in "Heat Transfer in Rod Bundles." The book also provides an overview and guidelines that can be used for the designer and the applied mathematician. This book is suitable for engineers working in electronics, aerospace, instrumentation, and biomechanics that use cooling or heating exchanges or solar collection systems.

Laminar Flow Forced Convection in Ducts is a sourcebook for compact heat exchanger analytical data. This book describes the analytical solutions for laminar fluid flow and forced convection heat transfer in circular and noncircular pipes, including applicable differential equations and boundary conditions involving velocity and temperature problems of fluid flow. The book also discusses fluid flow—how much power is required to pump fluids through the heat exchanger, as well as the heat transfer—the determination of q" distribution, and the temperature of fluid and walls. The text also analyzes the coolant or heat transfer fluid flows in a nuclear power reactor composed of a bundle of circular section fuel rods located inside a round tube. R.A. Axford addresses fluid flow and heat transfers results for the rod bundle geometry in "Heat Transfer in Rod Bundles." The book also provides an overview and guidelines that can be used for the designer and the applied mathematician. This book is suitable for engineers working in electronics, aerospace, instrumentation, and biomechanics that use cooling or heating exchanges or solar collection systems.

Details

ISBN

978-0-12-020051-1

Language

English

Published

1978

Copyright

Copyright © 1978 Elsevier Inc. All rights reserved.

Imprint

Academic Press

Authors

R.K. Shah

Harrison Radiator Division, General Motors Corporation, Lockport, New York 14094

A.L. London

Mechanical Engineering Department, Stanford University, Stanford, California 94305